Professional aluminum metallized film manufacturer for over 13 years experience.

learn how to repair broken 8mm film - silver coated polyester film

by:Cailong     2019-08-24
learn how to repair broken 8mm film  -  silver coated polyester film
If you are an independent filmmaker then you may be interested in using 8mm movies.
This type of film is 8mm wide and runs like a film strip.
If you already have an old movie of 8mm, then you may have a problem with the movie being torn in half.
This may bring you a question: how to repair the broken 8mm film?
Well, the first thing you want to do is figure out how many movies you can save.
Run the film through a project to determine how much of the film has been completely destroyed.
Some pieces may be slightly damaged but can be sold.
However, you just need to cut off the completely destroyed part.
Each frame of 8mm scenes is actually a separate box.
Going to the last frame is still available, and then using the scissors, the next frame is actually cut off.
Use a ruler as a guide and cut only on the line between two frames.
If not, you will damage the last good frame.
Once the bad part is removed, you will need to invest in some sort of movie shard.
Tape, cement, heat, and ultrasound are the four main types of film debris.
However, before you start reassembling your movie, you need to figure out if you need to add some type of transition.
If you only need to remove a frame or two, then your audience may notice that you have to remove a few frames.
If you have to remove the entire section of the movie, then you need to add some type of transition.
Use still images or even some type of header page to explain why chapters are missing or introduce the next set of actions.
You can use your fusion machine.
You can often buy these devices in your local garage sales, and tape splitters are often the most common type of splitters in these sales.
The tape connector reconnects the film together using tape.
You can use tape splitters on almost any type of film.
Cement debris uses chemical film cement to connect the film together.
You put the chemicals at the bottom of the end where you need to connect.
You can only use this chemical on certain types of films, including nitrate, acetate, or triacetate.
If you use this chemical on any other type of film, then you have the risk of destroying it.
You can use the thermal paper Splicer to connect most of the film together, using a label with a plastic coating.
When heated, this label is combined with the film and the two parts are kept together.
You can use this fusion splicer on different types of film.
The last one is the ultrasonic fusion splicer, which you can only use with polyester film.
This process basically melts the two membranes together.
If you use the process, you should have your movie sit for a while before moving.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Joey
Joey
Echo
Echo
Alen.Chen
Alen.Chen
Sign in with: